× For those of you with deep enough pockets

Twin turbine powered F-14 with inflight wing sweep

  • DominicM
  • DominicM's Avatar Topic Author
  • Offline
  • Elite Member
  • Elite Member
  • Vlogger for 'Essential RC'
More
20 Apr 2015 07:29 - 20 Apr 2015 07:30 #1 by DominicM
An amazing model to watch fly...and I caught the operational wing sweep working on the ground and in the air...


Vlogger for 'Essential RC'
www.youtube.com/c/essentialRC
Last edit: 20 Apr 2015 07:30 by DominicM.
Thanks: Eric, Klipkopwildlife, Quorneng, Ralpharr2001

Please Log in or Create an account to join the conversation.

More
20 Apr 2015 17:34 #2 by Eric
Nice model. I'd like to know how the builder managed to keep the centres of gravity and pressure in the same place with wings forward and aft. I tried to do the same, a long time ago, with a slope-soaring Tornado, and gave up in the end.

if you are calm and collected when all about you are going berserk - you've missed something important!

Please Log in or Create an account to join the conversation.

  • DominicM
  • DominicM's Avatar Topic Author
  • Offline
  • Elite Member
  • Elite Member
  • Vlogger for 'Essential RC'
More
21 Apr 2015 08:12 #3 by DominicM
Great question Eric. I will ask Mick when I next see him BUT I do recall him saying there was little perceptible change in flight characteristics with the wings swept and I don't think he has any trim changes programmed in when he sweeps either...but I will ask him.

Vlogger for 'Essential RC'
www.youtube.com/c/essentialRC
Thanks: Eric

Please Log in or Create an account to join the conversation.

  • Ex-Member
  • Visitor
  • Visitor
21 Apr 2015 16:08 #4 by Ex-Member
I made a paper F-14 recently that would allow the wings to be made with different sweep angles. It flew in all configurations without re-balancing and no significant change in wing or tail incidences. I suspect there's a small C of G range where this happens, but outside of that you have to trim with changes of wing sweep

Please Log in or Create an account to join the conversation.

Time to create page: 0.122 seconds